 |
no-OS
|
|
no-OS
|
Data structure used to read back CLGC calibration status. More...
#include <t_mykonos.h>
Public Attributes | |
| uint32_t | errorStatus |
| uint32_t | trackCount |
| int32_t | desiredGain |
| int32_t | currentGain |
| uint32_t | txGain |
| int32_t | txRms |
| int32_t | orxRms |
Data structure used to read back CLGC calibration status.
| int32_t mykonosClgcStatus_t::currentGain |
Current measured gain in 0.01 dB resolution.
| int32_t mykonosClgcStatus_t::desiredGain |
Desired gain/attenuation from Tx output to ORx input of Mykonos device. 0.01 dB resolution
| uint32_t mykonosClgcStatus_t::errorStatus |
| clgcErrorStatus(decimal) | Description |
|---|---|
| 0 | NO ERROR |
| 1 | TX Disabled |
| 2 | ORx is disabled |
| 3 | Loopback switch is clo |
| 4 | Data measurement aborted during capture |
| 5 | No initial calibration was done |
| 6 | Path delay not setup |
| 7 | No apply control is possible |
| 8 | Control value is out of range |
| 9 | CLGC feature is disabled |
| 10 | TX attenuation is capped |
| 11 | Gain measurement |
| 12 | No GPIO configured in single ORx configuration |
| 13 | Tx is not observable with any of the ORx Channels |
| 14 | ORX_TRACKING_DISABLED ORx tracking must be enabled |
| 15 | PA Protection Activated |
| 16 | Relative Threshold Violated |
| 17 | RESERVED |
| 18 | Tx power too low |
| 19 | ORx power too low |
| int32_t mykonosClgcStatus_t::orxRms |
ORx digital sample power measured at ORx port (0.01 dB resolution)
| uint32_t mykonosClgcStatus_t::trackCount |
Number of times CLGC tracking has run since last reset
| uint32_t mykonosClgcStatus_t::txGain |
Current TxAttenuation setting, same as MYKONOS_getTx1/2Attenuation(), in 0.05dB resolution
| int32_t mykonosClgcStatus_t::txRms |
Tx digital sample power measured at DPD block input (0.01 dB resolution)