USBCommands Enumeration |
This enum lists all supported vendor commands for the FX3 firmware. The LED commands can only be used with the ADI bootloader firmware.
Namespace: FX3Api
Assembly: FX3Api (in FX3Api.dll) Version: 2.9.4.0 (2.9.4)
SyntaxMembers| Member name | Value | Description | |
|---|---|---|---|
| ADI_I2C_SET_BIT_RATE | 16 | ||
| ADI_I2C_READ_BYTES | 17 | ||
| ADI_I2C_WRITE_BYTES | 18 | ||
| ADI_I2C_READ_STREAM | 19 | ||
| ADI_I2C_RETRY_COUNT | 20 | ||
| ADI_FIRMWARE_ID_CHECK | 176 | ||
| ADI_HARD_RESET | 177 | ||
| ADI_SET_SPI_CONFIG | 178 | ||
| ADI_READ_SPI_CONFIG | 179 | ||
| ADI_GET_STATUS | 180 | ||
| ADI_SERIAL_NUMBER_CHECK | 181 | ||
| ADI_WARM_RESET | 182 | ||
| ADI_SET_DUT_SUPPLY | 183 | ||
| ADI_GET_BUILD_DATE | 184 | ||
| ADI_SET_BOOT_TIME | 185 | ||
| ADI_GET_BOARD_TYPE | 186 | ||
| ADI_STREAM_GENERIC_DATA | 192 | ||
| ADI_STREAM_BURST_DATA | 193 | ||
| ADI_READ_PIN | 195 | ||
| ADI_READ_TIMER_VALUE | 196 | ||
| ADI_PULSE_DRIVE | 197 | ||
| ADI_PULSE_WAIT | 198 | ||
| ADI_SET_PIN | 199 | ||
| ADI_MEASURE_DR | 200 | ||
| ADI_PWM_CMD | 201 | ||
| ADI_TRANSFER_BYTES | 202 | ||
| ADI_BUSY_MEASURE | 203 | ||
| ADI_TRANSFER_STREAM | 204 | ||
| ADI_BITBANG_SPI | 205 | ||
| ADI_RESET_SPI | 206 | ||
| ADI_PIN_DELAY_MEASURE | 207 | ||
| ADI_STREAM_REALTIME | 208 | ||
| ADI_NULL_COMMAND | 209 | ||
| ADI_SET_PIN_RESISTOR | 210 | ||
| ADI_READ_BYTES | 240 | ||
| ADI_WRITE_BYTE | 241 | ||
| ADI_CLEAR_FLASH_LOG | 242 | ||
| ADI_READ_FLASH | 243 | ||
| ADI_LED_ON | 236 | ||
| ADI_LED_OFF | 237 | ||
| ADI_LED_BLINKING_OFF | 238 | ||
| ADI_LED_BLINKING_ON | 239 |
See Also