ADRV9042

The ADRV9042 models validate JESD204B/C transport settings and solve the external DEVCLK, SYSREF, clock generator, and FPGA clocks. Supply DEVCLK and each link’s interface sample rate from an ACE-approved configuration. Passing transport validation or solving a clock tree does not approve a complete firmware profile. Internal PLLs, RF LOs, DFE filters, carrier routing, and TDD link sharing are not synthesized. The model does not import ACE files or program hardware.

Combined operation

adijif.adrv9042 exposes framer0, framer1, framer2, deframer0, and deframer1. The aliases adc, obs, and dac refer to framer 0, framer 2, and deframer 0. Initially only framer 0 and deframer 0 are enabled.

system = adijif.system("adrv9042", "ad9528", "xilinx", 122_880_000)
system.fpga.setup_by_dev_kit_name("zcu102")
device = system.converter
device.reference_clock = 245_760_000
device.obs.enabled = True
device.obs.lane_mapping = [4, 5]
config = system.solve()

lane_mapping lists physical lanes in logical lane order and defaults to an identity mapping. Active links must use disjoint physical lanes within each direction. Opposite directions may reuse lane numbers. Hardware logical-lane capacities are 8/4/2 for framers and 8/4 for deframers. Active framers must have power-of-two sample-rate and lane-rate ratios. cddc_cduc_bypassed=True additionally limits M to 32. Routing observation data to a chosen framer remains part of the ACE configuration; the obs alias does not program a data crossbar.

The device requests one shared DEVCLK and equal-frequency SYSREF outputs for each active link. SYSREF candidates are exact common submultiples of DEVCLK and all active LMFC/LEMCs. sysref_dividers defaults to 1–64 and may be changed. Disabled links contribute no FPGA, JESD, or clock requirements. Editing profile settings and calling solve() again rebuilds the constraints; reapply any custom clock constraints when changing the configuration.

Only CPLEX is supported. Infeasible external clock or FPGA constraints produce a solver failure. Software checks do not establish physical link operation, clock phase noise, or SYSREF setup/hold margins.

Explorer’s JESD Mode Selector supports hardware-instance selection and E filtering. System Configurator exposes standalone links and the combined device, including all five enable controls, lane maps, and explicit DEVCLK entry. CLI/MCP uses the same registered names and supports nested converter_properties.

See examples/adrv9042_example.py for standalone and RX/ORx/TX clock solves.

Sources

  • UG-2358 Rev. 0: Tables 19 and 21, lane crossbars in Figures 55–57 and 62, and inter-framer sample-rate/lane-rate relationships on page 57.

  • ADRV9042 data sheet Rev. C: DEVCLK range of 61.44–491.52 MHz and interface sample rates.