Prerequisites

What you need, depends on what you are trying to do. As a minimum, you need to start out with:

Hardware prerequisites

  1. The AD9695/AD9697-based evaluation board: AD9695-1300EBZ

  2. An FPGA carrier platform. Our recommended one can be found here.

  3. Some way to interact with the FPGA platform:

    • Micro-USB cable for UART console

    • LAN cable (Ethernet) for SSH or IIO applications

    • HDMI or DisplayPort monitor (Optional)

    • USB Keyboard (Optional)

    • USB Mouse (Optional)

  4. A clock source, any low-noise clock generator with multiple outputs can be used. The following items are needed only if using the AD-SYNCHRONA14-EBZ:

    • AD-SYNCHRONA14-EBZ clock source board (Optional)

    • Serial port module for the AD-SYNCHRONA14-EBZ serial interface (Optional)

    • 20-pin GPIO ribbon cable for serial communication between the ZCU102 and the AD-SYNCHRONA14-EBZ, connected pin-to-pin, all 20 pins (Optional)

    • 3× SMA 50Ω terminators for unused AD-SYNCHRONA14-EBZ output channels (Optional)

  5. SMA cables (for connections between the clock source, AD9695, and signal generator)

  6. Low phase noise signal generator with antialiasing filter (analog input source)

  7. ZCU102 power supply (12 V)

  8. SD card with at least 16 GB of memory

Software prerequisites

  1. SD card 16 GB imaged with Kuiper (check out that guide on how to do it, then come back here).

  2. A UART terminal (PuTTY/Tera Term/Minicom), 115200 baud, 8N1.

  3. IIO Oscilloscope for data visualization.

Note

ADI does not offer FPGA carrier platforms for sale or loan; getting one yourself is the normal part of development or evaluation.