Quick Start

The quick start guides provide step-by-step instructions for the initial setup of the EVAL-ADMX100X-FMCZ evaluation board with the ADMX1001 or ADMX1002 modules.

Before proceeding, make sure you have completed the Prerequisites.

Supported Controller Boards

Controller Board

ADMX1001

ADMX1002

ZedBoard

Yes (via FMC LPC)

Yes (via FMC LPC)

SDP-H1

Yes (via FMC)

Yes (via FMC)

SDP-S SDP-B SDP-I-PMOD

No

Yes (via PMOD)

Quick Start with SDP-S or SDP-B (ADMX1002 Only)

  1. Verify the jumper and switch settings match Table 2 in the User Guide.

  2. Connect the ADMX1002 module to the module connector (P5).

  3. Configure the SDP-I-PMOD interposer before connecting:

    • Set JP1 to the SPI position.

    • Remove JP2.

  4. Connect the SDP-I-PMOD interposer to the PMOD header (P2) on the EVAL-ADMX100X-FMCZ board using the 6-pin PMOD cable. Connect the male end to the top row (pins 1–6) of the PMOD connector, aligning pin 1 of the cable with pin 1 of the connector. Connect the female end to the bottom row of P2.

  5. Connect the SDP-S or SDP-B controller to the SDP-I-PMOD interposer.

  6. Connect the SDP controller USB cable to the host PC.

  7. Apply power to the SDP-S or SDP-B using the 6 V power adapter. Wait 10 seconds for the controller to initialize.

  8. Apply power to the EVAL-ADMX100X-FMCZ board using the 12 V wall adapter.

  9. Set S1 to Loopback Off.

  10. Launch the ADMX100X GUI on the host PC.

Note

The SDP-S and SDP-B with SDP-I-PMOD do not support the ADMX1001 acquisition channel. Use the SDP-H1 for full ADMX1001 functionality.