Introduction to the ADALM2000

Basic Description

To use the ADALM2000` Active Learning Module, you have:

• Two-channel oscilloscope with differential inputs

• Two-channel arbitrary function generator

• 16-channel digital logic analyzer (3.3V CMOS and 1.8V or 5V tolerant, 100MS/s)

• 16-channel pattern generator (3.3V CMOS, 100MS/s)

• 16-channel virtual digital I/O

• Two input/output digital trigger signals for linking multiple instruments (3.3V CMOS)

• Two-channel voltmeter (AC, DC, ±25V)

• Network analyzer – Bode, Nyquist, Nichols transfer diagrams of a circuit. Range: 1Hz to 10MHz

• Spectrum Analyzer – power spectrum and spectral measurements (noise floor, SFDR, SNR, THD, etc.)

• Digital Bus Analyzers (SPI, I²C, UART, Parallel)

• Two programmable power supplies (0…+5V , 0…-5V)

• USB which for your host connectivity (used to stream data).

  • USB 2 (480 Mbits/seconds)

  • libiio USB device for communicating to the RF device

  • Network device

    • Remote Network Driver Interface Specification (RNDIS)

    • This will enumerate with the 192.168.2.1 IP address by default.

  • USB serial device

    • provides access to the Linux console on the M2K device via USB Communication Device Class Abstract Control Model (USB CDC ACM) specification

  • Mass Storage Device : this will appear to the host as a disk, where you can find links for software uploads, and the serial number of the device.

• External Power

  • The equipment shall be powered by SELV with limited energy according to IEC 61010-1cl.9.4 or LPS/PS2 power source according to IEC 60950-1 / IEC 62368-1.

  • An example external adapter (like this one from Adafruit).

• The device digital input/output is SELV compliant and less than 5 V and 5 A

• Environmental Conditions

  • Indoor use only

  • Operating Temperature @25C Ambient

  • Relative Humidity – 50%

Block Diagram

Pinout