Quickstart

The Quick Start Guides provide a simple step by step instruction on how to do an initial system setup for the ADRV9009-W/PCBZ, ADRV9008-1W/PCBZ and ADRV9008-2W/PCBZ boards on various FPGA development boards. They will discuss how to program the bitstream, run a no-OS program or boot a Linux distribution.

• ZCU102
  • Required Software
  • Required Hardware
  • Testing
    • Console Output
    • IIO Oscilloscope Remote

Supported carriers

The ADRV9009-W/PCBZ, ADRV9008-1W/PCBZ and ADRV9008-2W/PCBZ is, by definition a “FPGA mezzanine card” (FMC), that means it needs a carrier to plug into. The carriers we support are:

Board	ADRV9009-W/PCBZ	ADRV9008-1W/PCBZ	ADRV9008-2W/PCBZ
ZCU102	Yes	Yes	Yes
KC705
VC707
KCU105
ZC706	Yes	Yes	Yes
Arria 10 SoC	Yes	WIP	WIP

Supported Environments

The supported OS are:

Board	HDL	Linux Software	No-OS Software
ZCU102	Yes	Yes	WIP
KC705
VC707
KCU105
ZC706	Yes	Yes
Arria 10 SoC	Yes	Yes

Hardware Setup

In most carriers, the ADRV9009-W/PCBZ, ADRV9008-1W/PCBZ and ADRV9008-2W/PCBZ boards connects to the HPC1 connector (unless otherwise noted). The carrier setup requires power, UART (115200), ethernet (Linux), HDMI (if available) and/or JTAG (no-OS) connections. A few typical setups are shown below.

ZCU102 + ADRV9009/PCBZ

Unboxing guide

Detailed unboxing guide