Quickstart

The Quick Start Guides provide a simple step by step instruction on how to do an initial system setup for the EVAL-ADRV9026/ADRV9029 boards on various FPGA development boards. They will discuss how to program the bitstream, run a no-OS program or boot a Linux distribution.

• ZCU102
  • Required Software
  • Required Hardware
  • Testing
    • Console Output
  • IIO Oscilloscope Remote
• VCK190
  • Required Software
  • Required Hardware
  • Testing
  • ACAP SDcard boot files
  • Setting up UART
  • Boot messages
    • Console Output
  • IIO Oscilloscope Remote

Supported carriers

The EVAL-ADRV9026/ADRV9029, is, by definition a “FPGA mezzanine card” (FMC), that means it needs a carrier to plug into. The carriers we support are:

Board	EVAL-ADRV9026	EVAL-ADRV9029
ZCU102	Yes	Yes
KC705
VC707
KCU105
ZC706
VCU118	Yes	Yes
VCK190	Yes	Yes
Arria 10 SoC	Yes	Yes

Supported Environments

The supported OS are:

Board	HDL	Linux Software	No-OS Software
ZCU102	Yes	Yes	Yes
KC705
VC707
KCU105
ZC706
VCU118	Yes	Yes	Yes
VCK190	Yes	Yes	Yes
Arria 10 SoC	Yes	Yes

Hardware Setup

In most carriers, the EVAL-ADRV9026/ADRV9029 boards connects to the HPC1 connector (unless otherwise noted). The carrier setup requires power, UART (115200), ethernet (Linux), HDMI (if available) and/or JTAG (no-OS) connections. A few typical setups are shown below.

ZCU102 + EVAL-ADRV9026/ADRV9029

VCK190 + EVAL-ADRV9026/ADRV9029

Unboxing guide

Detailed unboxing guide