AD936x

Overview

The AD936x plugins for Scopy enable integration and control of AD936x-based devices within the Scopy software environment. These plugins allow users to visualize, analyze, and interact with RF signals and data streams via Scopy’s intuitive interface.

Features

• Device Discovery: Automatic detection of connected PlutoSDR or AD936x devices.

• Signal Acquisition: Real-time streaming of I/Q data from the device.

• Device Configuration: Set parameters such as center frequency, bandwidth, sample rate, and gain.

Supported Devices

• AD936x Family (including AD9361, AD9364, and compatible SDR platforms)

• ADALM-Pluto (PlutoSDR) (based on Analog Devices AD9363)

• AD-FMCOMMS2/3/4 (with AD9361/AD9364)

• AD-FMCOMMS5 (with AD9361/AD9364)

Getting Started

Prerequisites

• A supported SDR device (PlutoSDR or AD936x-based platform)

• Properly installed device drivers (see ADI Drivers)

• Scopy version 2.1.0 or later

Using the Plugin

Configuration Options

Parameter	Description	Typical Range
Center Frequency	Tuning frequency of the SDR	325 MHz – 3.8 GHz
Sample Rate	ADC/DAC sample rate	520 kHz – 61.44 MHz
Bandwidth	RF bandwidth	Up to 20 MHz
RX/TX Gain	Receiver/transmitter gain	-89.75 dB to 0 dB (step: 0.25 dB)

Troubleshooting

• Device Not Detected: Ensure drivers are installed and the device is connected via USB.

• Signal Quality Issues: Check antenna connections, adjust gain and frequency.

Additional Resources

• ADALM-Pluto Wiki

• AD936x Family Overview

• AD936X
  • Description
  • Device Global Settings
  • Receive Chain
  • Transmit Chain
  • Block Diagram
• AD936X Advanced
  • ENSM/Mode/Clocks
  • Gain Control
  • RSSI
  • External LNA
  • TX Monitor
  • Axillary IO (ADC, DAC, Control IO, Temp Sensor)
  • MISC
  • BIST