Quickstart

The Quick Start Guides provide a simple step by step instruction on how to do an initial system setup for the EVAL-AD-FMCOMMS4 boards on various FPGA development boards. They will discuss how to program the bitstream, run a no-OS program or boot a Linux distribution.

• On ZCU102
  • Using Linux as software
    • Necessary files
    • Required software
    • Required hardware
    • Testing
      • Creating the setup
      • Boot messages
      • Useful commands for the serial terminal
  • Using no-OS as software
    • Necessary files
    • Required Software
    • Required Hardware
    • Testing
      • Creating the setup
      • Console output
• On KCU105
  • Using Linux as software
    • Necessary files
    • Required Software
    • Required hardware
    • Testing
      • Creating the setup
      • Boot messages
      • Useful commands for the serial terminal
  • Using no-OS as software
    • Necessary files
    • Required Software
    • Required Hardware
    • Testing
      • Creating the setup
      • Console output
• On ZC706
  • Using Linux as software
    • Necessary files
    • Required software
    • Required hardware
    • Testing
      • Creating the setup
      • Boot messages
      • Useful commands for the serial terminal
  • Using no-OS as software
    • Necessary files
    • Required Software
    • Required Hardware
    • Testing
      • Creating the setup
      • Console output
• On ZC702
  • Using Linux as software
    • Necessary files
    • Required software
    • Required hardware
    • Testing
      • Creating the setup
      • Boot messages
      • Useful commands for the serial terminal
  • Using no-OS as software
    • Necessary files
    • Required Software
    • Required Hardware
    • Testing
      • Creating the setup
      • Console output
• On ZED
  • Using Linux as software
    • Necessary files
    • Required Software
    • Required Hardware
    • Testing
      • Creating the setup
        • AD-FMCOMMS4-EBZ/ZED
      • Boot messages
      • Useful commands for the serial terminal
  • Using no-OS as software
    • Necessary files
    • Required Software
    • Required Hardware
    • Testing
      • Creating the setup
      • Console output

Supported carriers

The AD-FMCOMMS4-EBZ is, by definition a “FPGA mezzanine card” (FMC), that means it needs a carrier to plug into. The supported carriers can be found here.

Supported environments

The supported environments can be found here.

Hardware setup

On most carriers, the AD-FMCOMMS4-EBZ board connects to the LPC connector (unless otherwise noted). The carrier setup requires power, UART (115200), ethernet (Linux), HDMI (if available) and/or JTAG (no-OS) connections. A few typical setups are shown below.

ZC702 + FMCOMMS4

Early versions of the ZC702 carriers need to work around AR# 51438, PG signal does not assert by default errata.

Go to the setup guide.

ZC706 + FMCOMMS4

Go to the setup guide.

ZED + FMCOMMS4

Go to the setup guide.

ZCU102 + FMCOMMS4

Go to the setup guide.

KCU105 + FMCOMMS4

Go to the setup guide.