Quick start

The quick start guide provides step-by-step instructions on how to do an initial system setup for the EVAL-AD9783 evaluation board on the supported FPGA carrier or controller boards. This guide covers how to prepare the SD card, program the bitstream, and boot Kuiper Linux.

• On ZCU102 (ZynqMP)
  • Supported Devices
  • Supported Carriers
  • Functional Description
    • Block Diagram
    • Description
      • Creating the constraints
  • Quick Start Guide
    • Required Hardware
    • Required Software
    • Setup
    • Troubleshooting
• On SDP-H1
  • Preface
  • Typical setup
  • Software needed
  • Hardware needed
  • Quick start guide

Supported carriers

The EVAL-AD9783 connect to the FPGA carrier via SPI and GPIO signals, routed through an AD-DAC-FMC adapter board.

FPGA board	EVAL-AD9783
ZCU102 (ZynqMP)	SPI

Supported controller boards

The EVAL-AD9783 connect to the high speed controller boards via SPI and GPIO signals, routed through an AD-DAC-FMC adapter board.

Supported environments

FPGA board	HDL	Linux software	No-OS software
ZCU102 (ZynqMP)	Yes	Yes	—