Quick start

The Quick start guides provide simple step by step instructions on how to do an initial system setup for the EVAL-ADRV903x boards on various FPGA development boards. In these guides, we will discuss how to program the bitstream, run a no-OS program or boot a Linux distribution.

• On ZCU102
  • Using Linux as software
    • Necessary files
    • Required Software
    • Required Hardware
    • Testing
      • Creating the setup
      • Boot messages
      • Verifying the setup
      • Using IIO Oscilloscope
      • Next steps
  • Using no-OS
    • Building the project
    • Running the project

Supported carriers

The EVAL-ADRV903x, is, by definition a “FPGA mezzanine card” (FMC); that means it needs a carrier to plug into.

The carriers we support are listed below, as well as the FMC port where to connect the evaluation board:

FPGA board	EVAL-ADRV9032	EVAL-ADRV9032R
ZCU102	FMC HPC1	FMC HPC1

Supported Environments

The supported OS are:

FPGA board	HDL	Linux software	No-OS software
ZCU102	Yes	Yes	Yes

Hardware Setup

On most carriers, the EVAL-ADRV903x boards connects to the HPC1 connector (unless otherwise noted). The carrier setup requires power, UART (115200), Ethernet (Linux), HDMI (if available) and/or JTAG (no-OS) connections. A few typical setups are shown below.

ZCU102 + EVAL-ADRV9032

The EVAL-ADRV9032 evaluation board connects to the FMC HPC1 connector on the ZCU102. Typical hardware setup includes:

• Power supply for ZCU102

• FMC connection between EVAL-ADRV9032 and ZCU102 HPC1

• UART connection (115200 baud)

• Ethernet connection for Linux networking

• HDMI connection to monitor (optional)

• SD card with boot files and Linux distribution

For detailed connection information and setup photos, please refer to the ADRV903x System Development User Guide.