Quickstart

The Quick Start Guides provide a simple step by step instruction on how to do an initial system setup for the AD9084-FMCA-EBZ evaluation board on various FPGA development boards. They will discuss how to program the bitstream, run a no-OS program or boot a Linux distribution.

• Virtex UltraScale+ VCU118/VCU128
  • Required Hardware
  • Required Software
  • Building the HDL project
  • Build the Linux files
  • Testing
• Versal ACAP VCK190/VPK180
  • Required Hardware
  • Required Software
  • Building the HDL project
  • Building the Linux files
  • Testing
• Intel Agilex 7 I-Series
  • Required Hardware
  • Required Software
  • Build the Linux files
  • Building the HDL project
  • Programming steps
  • Testing
• Running a new JESD mode on hardware

Supported carriers

The AD9084-FMCA-EBZ is, by definition a “FPGA mezzanine card” (FMC), that means it needs a carrier to plug into. The carriers we support are:

Board	AD9084-FMCA-EBZ	Side A lanes	Side B lanes	FMC+ risers required
KC705	No
KCU105	No
VC707	No
VCU118	Yes	12	12	2
VCU128	Yes	12	12	2
VCK190	Yes	4	4	2
VPK180	Yes	4	4	0
ZCU102	No
ZC706	No
Arria 10 SoC	No
Stratix 10 SoC	No
Agilex 7 SoC I-Series	Yes	8	8	1

Supported Environments

The supported environments are:

Board	HDL	Linux Software	No-OS Software
KC705
KCU105
VC707
VCU118	Yes	Yes	WIP
VCU128	Yes	Yes	WIP
VCK190	Yes	Yes	WIP
VPK180	Yes	Yes	WIP
ZCU102
ZC706
Arria 10 SoC
Stratix 10 SoC
Agilex 7 SoC I-Series	Yes	Yes	No