Quickstart

The Quick Start Guides provide step by step instructions on how to set up the EVAL-CN0540-ARDZ board on various supported platforms, including FPGA development boards (HDL/Linux) and MCU boards running a bare-metal MBED application.

• CoraZ7-07s
  • Requirements
    • Hardware
    • Software
  • Setup
    • SD-Card
    • Download and Install IIO-Oscilloscope
    • CoraZ7-07s Hardware Configuration
    • Cables & Connectors
    • Boot Sequencing
    • Finding your CN0540
    • Using the System with IIO Oscilloscope
• DE10-Nano
  • Requirements
    • Hardware
    • Software
  • Setup
    • SD-Card
    • Download and Install IIO-Oscilloscope
    • DE10-Nano Hardware Configuration
    • Cable & Connectors
    • Boot Sequencing
    • Finding your CN0540
    • Using the System with IIO Oscilloscope
• SDP-K1
  • Equipment
  • Hardware Setup
  • Software Setup
    • Importing the EVAL-CN0540-ARDZ MBED Example program
    • Connecting to a serial terminal application
    • Command Summary
• STM Discovery Kit
  • Equipment
  • Hardware Setup
  • Software Setup
    • Porting the MBED Example program to DISCO-F746NG
    • Installing the 32F746 Discovery Board driver
    • Designing a User Interface using the 32F746NG Discovery board

Supported carriers

The carriers we support are:

• Cora Z7S on Arduino shield connector

• DE10-Nano on Arduino shield connector

• SDP-K1 on Arduino shield connector

• 32F746GDISCOVERY on Arduino shield connector

Supported Environments

The supported OS are:

Board	HDL	Linux Software	No-OS Software	MBED
Cora Z7S	Yes	Yes	Yes	No
DE10-Nano	Yes	Yes	Yes	No
SDP-K1	No	No	No	Yes
32F746GDISCOVERY	No	No	No	Yes

Hardware Setup

The EVAL-CN0540-ARDZ board connects to the Arduino Shield connector (unless otherwise noted). The carrier setup requires power, UART (115200), ethernet (Linux), HDMI (if available) and/or JTAG (no-OS) connections.

A few typical setups are shown below.

CoraZ7-07s + EVAL-CN0540-ARDZ

DE10-Nano + EVAL-CN0540-ARDZ