Quickstart

The Quick start guides provide simple step by step instructions on how to do an initial system setup for the EVAL-AD7134FMCZ board on various FPGA development boards. In these guides, we will discuss how to program the bitstream, run a no-OS program or boot a Linux distribution.

• Zedboard
  • Using Linux as software
    • Necessary files
    • Required Software
    • Required Hardware
    • Testing
      • Creating the setup
        • EVAL-AD7134FMCZ/ZED
      • Boot messages
      • Useful commands for the serial terminal
    • Scopy
    • IIO Oscilloscope
  • Using no-OS as software
    • Necessary files
    • Required Software
    • Required Hardware
    • Testing
      • Creating the setup
        • EVAL-AD7134FMCZ/ZED
      • Console output

Supported carriers

The EVAL-AD7134FMCZ, is, by definition a “FPGA mezzanine card” (FMC); that means it needs a carrier to plug into.

The carriers we support are:

FPGA board	EVAL-AD7134-FMCZ
ZedBoard	FMC LPC

Supported Environments

The supported OS are:

FPGA board	HDL	Linux software	No-OS software
ZedBoard	Yes	Yes	Yes

Hardware Setup

The EVAL-AD7134FMCZ board connects to the FMC LPC connector of the carrier board. The carrier setup requires power, UART (115200), ethernet (Linux), HDMI (if available) and/or JTAG (no-OS) connections.

A few typical setups are shown below.

ZedBoard + EVAL-AD7134FMCZ

Figure 1 ZedBoard + EVAL-AD7134FMCZ hardware setup