Quick Start

The Quick Start Guides provide simple step-by-step instructions on how to do an initial system setup for the EVAL-AD4080-FMC, EVAL-AD4083-FMC and EVAL-AD4086-FMC boards on various FPGA development boards. They will discuss how to program the bitstream, run a no-OS program or boot a Linux distribution.

• On Zedboard

Supported Carriers

The EVAL-AD4080-FMC, EVAL-AD4083-FMC and EVAL-AD4086-FMC are, by definition, “FPGA mezzanine cards” (FMC), which means they need a carrier to plug into. The carriers we support are:

Board	EVAL-AD4080-FMC	EVAL-AD4083-FMC	EVAL-AD4086-FMC
Zedboard	FMC LPC	FMC LPC	FMC LPC

Supported Environments

The supported environments are:

FPGA board	HDL	Linux software	no-OS software
Zedboard	Yes	Yes	—

Hardware Setup

In most carriers, the EVAL-AD4080-FMC, EVAL-AD4083-FMC and EVAL-AD4086-FMC boards connect to the LPC connector (unless otherwise noted). The carrier setup requires power, UART (115200), ethernet (Linux), and HDMI (if available). A few typical setups are shown below.

Zedboard + EVAL-AD4080-FMC