ZC706 Quick Start Guide

Warning

The AD-FMCADC7-EBZ is a legacy product and is no longer actively supported. This documentation is provided for reference only.

This guide provides step-by-step instructions on how to set up the AD-FMCADC7-EBZ on:

Required Software

  • SD card image or pre-built bitfile and Linux image from the last supported release (2021_r2).

  • A UART terminal (Tera Term / Minicom), baud rate 115200 (8N1).

Required Hardware

  • Xilinx ZC706

  • AD-FMCADC7-EBZ FMC Board

  • Micro/Mini-USB Cable

  • Ethernet cable

  • SD card (for Linux boot)

Linux Quick Start

All you need to do is build or download the SD card image of the latest supported release. The instructions are here.

The Zynq carrier programs the FPGA and boots Linux from the SD card. Please follow the specific switch settings for Linux mode on the ZC706.

IIO Oscilloscope Remote

Please see also here: IIO Oscilloscope

The IIO Oscilloscope application can be used to connect to another platform that has a connected device in order to configure the device and read data from it.

Build and start osc on a network-enabled Linux host.

Once the application is launched, go to Settings -> Connect and enter the IP address of the target in the popup window.