Quick start

The quick start guide provides step-by-step instructions on how to do an initial system setup for the EVAL-AD7770-AD7779 evaluation board on the supported FPGA development board. This guide covers how to prepare the Kuiper Linux SD card and boot the system.

• On ZedBoard
  • Using Linux as software
    • Necessary files
    • Required software
    • Required hardware
  • Testing
    • Creating the setup
    • Boot messages
    • Useful commands
    • IIO Oscilloscope
• On SDP-K1 / Nucleo-L552ZEQ (legacy)
  • Overview
  • Hardware connections
    • SDP-K1 (MBED platform)
    • Nucleo-L552ZEQ (STM32 platform)
    • EVAL-AD777x
  • Firmware
    • app_config.h
  • Running IIO Oscilloscope
    • Device attributes
    • DMM tab
    • Data capture
    • Register map
  • Useful links

Supported carriers

The EVAL-AD7770-AD7779 connects to the FPGA carrier via an FMC LPC connector.

FPGA board	EVAL-AD7770-AD7779
ZedBoard	FMC LPC

Supported environments

FPGA board	HDL	Linux software	No-OS software
ZedBoard	Yes	Yes	In development

Hardware setup

The EVAL-AD7770-AD7779 mounts on the ZedBoard via the FMC LPC connector. The carrier setup requires a Micro-USB cable for UART, a network cable for Ethernet, and a prepared Kuiper Linux SD card.

ZedBoard + EVAL-AD7770-AD7779

Figure 1 ZedBoard with EVAL-AD7770-AD7779 hardware setup

Go to the quick start guide.